Genesis GMSDB1512L Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 22)

English

12" Sliding Compound Miter Saw

Operator’s Manual GMSDB1512L

MAINTENANCE

WARNING: Always be sure the miter saw is disconnected from the power source

before making any adjustments or during set-up prior to cutting. Failure to disconnect or

unplug the machine may cause accidental starting, resulting in serious personal injury.

BELT REPLACEMENT (FIG 30)

The saw is powered by a belt-driven motor. Periodically check the

belt for wear and replace it when necessary.

Proceed as follows when replacement is required:

1. Unplug the saw.

2. Pull the saw head down and lock it to be in transportation

position.

3. Using Phillips screwdriver, remove the screws from the belt

cover (1). Lift the cover off the housing and set aside.

4. Loosen all 6 adjustment screws (2) by using 5mm Allen key

5. Loosen the set screw (3) on the motor housing by using 4mm

Allen key until there is enough slack in the belt (4) for it to be

removed from the pulleys.

6. Place the new belt around pulleys. (Groove turned to the

inside)

7. Retighten the set screw (3).

8 Check belt tension by squeezing the belt. Using light pressure, the belt should deﬂect approximately 1/4 in.

NOTE: If belt tension is not correct, adjust the set screw until tension is correct.

9. Once belt tension is correct, retighten adjustment screws.

10. Reinstall the belt cover.

CLEANING

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING: Do not at any time let brake ﬂuids, gasoline, petroleum-based

products, penetrating oils, etc., come in contact with plastic parts. Chemicals can

damage, weaken or destroy plastic which may result in serious personal injury.

Electric tools used on ﬁberglass material, wallboard, spackling compounds, or plaster are subject to accelerated

wear and possible premature failure because the ﬁberglass chips and grindings are highly abrasive to bearings,

brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these

types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool

using compressed air.

LUBRICATION

This tool is permanently lubricated at the factory and requires no additional lubrication.

FIG 30

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Keine Kommentare

Genesis GMSDB1512L Gebrauchs- und Pflegehandbuch Seite 22